frostynugglets
New Member
Hey!
I downloaded and tried to print a Halo 4 Raider Helmet but the full wearable helmet is too big to print all at once. I was hoping there was someone who is good with the sculpting programs that might be able to section it out. I think if the face plate is separated from the main helmet I can use magnets to attach it but I would also need the helmet to be cut in half. I am not sure if that makes much sense but I am willing to elaborate if needed.
I downloaded and tried to print a Halo 4 Raider Helmet but the full wearable helmet is too big to print all at once. I was hoping there was someone who is good with the sculpting programs that might be able to section it out. I think if the face plate is separated from the main helmet I can use magnets to attach it but I would also need the helmet to be cut in half. I am not sure if that makes much sense but I am willing to elaborate if needed.