Belakor
Well-Known Member
LastSpartan said:So, basicly, you're dividing your models into piece small enough for the Cupcake CNC?
How well does it work?
That's what I was looking at doing at one point, though right now my Cupcake is out of commission... the local plastic supplier changed their dies so the ABS filament is too big to properly fit in the heater (went from 2.9mm to 3.1mm) so it's just sitting and gathering dust until I get new plastic from the states or change the bore size
For the moment all I'm doing is rendering my better finished models in high res (6500 x 4500px, which is about 10-15MB per image) and they'll be sent off for printing in a more traditional sense. That is they'll all be in a hardcover book
Off to finishing moving houses and start another render... they're coming in at about 2 hours each so I have to find something else to do in the meantime
Last edited by a moderator: