Dropping in Hot with my ECCC Master Chief.


Member DIN
Spartan John, Gig Harbor, Wa...Hello all!
Great looking armor set. The details and weathering are well done!
Sorry its taken so long to get back. Thank you so much! I worked really hard on the details and weathering. I did several tutorial streams about it and discussed it briefly in my build thread. If you have any questions please ask, I have techniques for both PLA print and EVA foam weathering.


  • 3E23B340-1096-42F2-88E6-B93F9875AF67 (1).jpg
    3E23B340-1096-42F2-88E6-B93F9875AF67 (1).jpg
    2.3 MB · Views: 60
This thread is more than 12 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.