cottenmouthsnake
New Member
Have you ever started a project from pepakura then lost a part because of anything, and forgot what height or scale you did it with then here is a simple way that I can show how.
First find a piece you have printed out on a piece paper, measure it.
the find the same peice on pepakura print it out on paper and measure the same side.
then find the scale of the craft by going to the 2Dpatternwindow on pepakura.
then put you data in a proportion way like this
your pieces size....printed piece of papers size
---------------- ~ ----------------------------
......A...................scale of it
then cross multiply and you get
printed piece of papers size x A = your pieces size x scale of it
then just solve for A. A= the scale you need to print out you missing piece with.
I got it to within a couple of mm and I played with the hieth number Until it was the size I needed
Hope this helps
If you have questions post a reply.
First find a piece you have printed out on a piece paper, measure it.
the find the same peice on pepakura print it out on paper and measure the same side.
then find the scale of the craft by going to the 2Dpatternwindow on pepakura.
then put you data in a proportion way like this
your pieces size....printed piece of papers size
---------------- ~ ----------------------------
......A...................scale of it
then cross multiply and you get
printed piece of papers size x A = your pieces size x scale of it
then just solve for A. A= the scale you need to print out you missing piece with.
I got it to within a couple of mm and I played with the hieth number Until it was the size I needed
Hope this helps
If you have questions post a reply.