Halo 2 Stationary Human Turret

Status
Not open for further replies.

silvercookie

Well-Known Member
I am going to begin working on this today, start with base then bar then shield, gun, etc, etc.

if i manage to get the base cut out i will post pics :)
 
this is the base
0428071746.jpg

this the base compared to xbox 360 controller to show size
0428071747.jpg
 
WHAT IS HALO 2 DOING OUTSIDE OF ITS BOX? WHY DO YOU SOIL THE HOLY RELIC?!

Jk.
Nice yob on the base so far.
 
umm i think hes talking about your halo 2 disc is just setting on a magazine over there on the left.
 
o good point

edit: when i am done with the base i am going to go to home depot and get it cut out of sheet metal or sometin so it will be full weight an everything.

i also need ideas on how to make the support bar, like what to use to get it hooked.
 
ok dr. spock ill get right on that.

ill leave it to the people at homedepot this way if they mess it up it was their fault not mine
 
no offence, but how old are you? it takes about five min to cut through a steel pipe with a hacksaw. welding would take longer though. and that is if you have had classes for welding
 
Status
Not open for further replies.
Back
Top