Looking at the specs, it looks like Bungie based the M12's Vulcan MG on it. If anyone was to make a real mil-spec Hog, they would probably use one of these.y
Looking at the specs, it looks like Bungie based the M12's Vulcan MG on it. If anyone was to make a real mil-spec Hog, they would probably use one of these.y
i use a putty primer spray from repco as well as a spot putty for larger areas that need filling though both can be a pain to sand infact the spot putty gets so hard you can not sand it by hand.... if you like we could have a chat about teh 3d printing and finishing process
AH!! right you use ABS right i use PLA... not gonna lie its a pain in the ass to finish.... and no problem best thing to use on the putty is 400-1200 grit wet and dry and make sure its got plenty of water on it otherwise the paper just loses its bite
SO now that the commission is outta the way... i only have another 2 to go... BUT ill work on the DMR while i wait for stuff to set and dry even thought this was taken a number of weeks ago i hope this peace offering will work and tied you all over till i get some actual progress done >.>
and you should SO check out my M6H i posted up a little surprise hehehehe down the bottom MWAHAHAHAHA