Halo Infinate 3D printed build

[WolfS117]

Hey! Looks cool, where did you get the fan, looks like it would do a decent job, I want

It's just a noctua 40mm. I only have it supplied with 12v on a simple switch so when it's on its full speed. I would reccomend wrapping the edge in some foam of some description to isolate some of the noise. The vibrations are amplified in the helmet without something for isolation.

The mount was custom 3d design, it wasn't anything special, I formed it a bit and then used hot glue to secure it in place

Noctua NF-A4x10 PWM, Premium Quiet Fan, 4-Pin (40x10mm, Brown) Noctua NF-A4x10 PWM, Premium Quiet Fan, 4-Pin (40x10mm, Brown) : Amazon.co.uk: Computers & Accessories

 

[WolfS117]

Shoulders have slipped and the belt is a bit low but it's very comfortable considering what it is.

 

[WolfS117]

Lots of fun on the first propper time out. Lots of changes to do. The belt kept slipping down showing the podge. Forearms need reprinting.