So a while back I acquired a hasbro clone trooper helmet and its been just sitting on a box taunting me with it's ugliness. So I decided it was finally time to spruce it up a little bit. I'm 95% it would be a waste of time to even attempt to get it 501st approvable. However for something that is going to sit in my helmet collection I want it to at least look good. That being said I may have forgotten to take some pics during disassembly and reassembly.
The good news is I took some pics while enhancing it. Once whats on there hardens and I grab another tube of jb weld I'll finish off filling in all the holes and such. Then I will proceed to the sanding part....then fill...then sand...ect.
Now since I know there are 501st members here I would like some opinions if you would be so kind. (The visor area I may still alter again since it feels too large.)
Some minor things to point out. I'm going to fill and redrill the holes in the front. I'm going to make 2 more lines on the sides below the ear tower.The ear will have a proper hole and not whatever it had originally. And with eventuality it will have a proper paint job and the such.
The good news is I took some pics while enhancing it. Once whats on there hardens and I grab another tube of jb weld I'll finish off filling in all the holes and such. Then I will proceed to the sanding part....then fill...then sand...ect.
Now since I know there are 501st members here I would like some opinions if you would be so kind. (The visor area I may still alter again since it feels too large.)
Some minor things to point out. I'm going to fill and redrill the holes in the front. I'm going to make 2 more lines on the sides below the ear tower.The ear will have a proper hole and not whatever it had originally. And with eventuality it will have a proper paint job and the such.