Helmet Electronics and Inside

Cyno

New Member
Can someone show/breakdown how they have the inside of their helmet set up? I have an Infinite Chief helmet and I am planning on putting at LEAST 2 fans, LEDs in the flashlight holes, a battery pack, and some foam.
 
I know JTF4 is incredibly busy at the moment, but he has a great Infinite Chief build that has lights. You may be able to pull him aside and ask a few questions after things have settled down a little bit.

Kind regards,
Kae
 
I did fans, mic transmitter, and hearing assist system. The circuit could easily be modified to add some lights. Here's my diagram (and a picture of the result on the next page)
 
I did fans, mic transmitter, and hearing assist system. The circuit could easily be modified to add some lights. Here's my diagram (and a picture of the result on the next page)
Do you have a picture of the inside? I mostly meant how people wired it to not be annoying but still be secure.
 
Do you have a picture of the inside? I mostly meant how people wired it to not be annoying but still be secure.
Yeah there's a picture a few posts down. It got bumped to the last page. Here's a link for your convenience:
 
Yeah there's a picture a few posts down. It got bumped to the last page. Here's a link for your convenience:
Sick! Thank you. I didnt even realize there was more.
 
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top