Helmet Electronics and Inside

Cyno

New Member
Can someone show/breakdown how they have the inside of their helmet set up? I have an Infinite Chief helmet and I am planning on putting at LEAST 2 fans, LEDs in the flashlight holes, a battery pack, and some foam.
 
I know JTF4 is incredibly busy at the moment, but he has a great Infinite Chief build that has lights. You may be able to pull him aside and ask a few questions after things have settled down a little bit.

Kind regards,
Kae
 
I did fans, mic transmitter, and hearing assist system. The circuit could easily be modified to add some lights. Here's my diagram (and a picture of the result on the next page)
 
I did fans, mic transmitter, and hearing assist system. The circuit could easily be modified to add some lights. Here's my diagram (and a picture of the result on the next page)
Do you have a picture of the inside? I mostly meant how people wired it to not be annoying but still be secure.
 
Do you have a picture of the inside? I mostly meant how people wired it to not be annoying but still be secure.
Yeah there's a picture a few posts down. It got bumped to the last page. Here's a link for your convenience:
 
Yeah there's a picture a few posts down. It got bumped to the last page. Here's a link for your convenience:
Sick! Thank you. I didnt even realize there was more.
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top