Helmet template question

Status
Not open for further replies.

PillarofAutumn

Member
So, for my foam Helljumper helmet... template's got the right and left sides made differently (right out of a few large pieces, left from a bunch of smaller ones, just like the armor). I wouldn't mind this normally, but that the little circle-in-an-oval bit just behind and above the visor on the right side is such a convoluted mess it'll take me probably a month or so to organize the template there enough to start. What happens if, instead, I remove that section from the panel and mirror the matching set on the left over? Would that work as a (hopefully) simpler solution, or am I doomed to untying the knot?
 
I know, I know, I get that all the time.


So humble.....

giphy-downsized.gif
 
Status
Not open for further replies.
Back
Top