How could i make the Katana from Halo 3

Discussion in 'Halo Costumes and Armor' started by DarthDratinni, Jan 9, 2019.

  1. DarthDratinni

    DarthDratinni New Member

    Trophy Points:
    2
    Would it be possible to make this using Eva-foam? or something similar?
     

    Attached Files:

  2. xXDashIVXx

    xXDashIVXx Active Member

    Trophy Points:
    245
    Difinatley! If you have a belt sander, this is easy peasy! Just get a cheap colfclub from the thrift store and cut the head off, or find some sort of pole or anything long, skinny, and stiff to reinforce the foam and make it not floppy. Then cut out two long strips and put a "trench" in the middle of each of them for the pole to sit in, and glue together. Then sand yo shape. Should be simple if you dont want to paint a cheap plastic one. I think oden makes made a good tutorial on swords and katanas!
     
  3. DarthDratinni

    DarthDratinni New Member

    Trophy Points:
    2
    i was going to do that or use or this pole extender i found i would just have sand it down a bit
     
    xXDashIVXx likes this.

Share This Page