i need some measurments

Status
Not open for further replies.
shadow8136 said:
i also need help.... i need to know how u make the pep helm fit almost EXACTLY....

like, if u go to pepakura designer, click "2D Pattern Window", then go to "Scale Up/Down by Specifying Value"
then, its the problem.... i printed it out as 27 cm, WAY TOO SMALL i made the face so far, but i can already tell how small it is...

HELP ME
lastspartan is right you have to read the stickies, in your case you should check out the scaling thread.
 
Last edited by a moderator:

AoBfrost

Well-Known Member
Read the stickies before asking. Also, asking a question in someone else's thread could cause thread hijacking, which isnt good.
 
Status
Not open for further replies.
Top