New and need some help

Take your time.

There are entire sections dedicated to tutorials and material.

We have an index of tutorials as a place to start:

There is plenty to learn! Welcome to the Forum!
 
In addition to the threads in the Tutorial Index, here are two good reads for any new 3D printer:

 
This thread is more than 8 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top