That looks very nice, I was expecting some cardboard and duct tape, and a worse design. Very nice, just like that other guy, if you put in enough work, it should be molded or something like that other guy's.
That looks very nice, I was expecting some cardboard and duct tape, and a worse design. Very nice, just like that other guy, if you put in enough work, it should be molded or something like that other guy's.
WOW, can i recomend something, if u intend to make it really good, ill tell you what i tried doing
get an old pair of sunglasses and pop out the lesnes and attatch them to the inside of the armor, then wire up blue LEDS underneath them, probabily the best way to get the lights there
I noticed that the shape of the eyes are wrong, so I'll try to fix that, and I'm still trying to figure out the best way to make the forehead and cranium of the helmet... it's hard to make domed surfaces with cardboard!
You could try tracing the hole on paper and refine it, then trace it agian on cardboard, and then place it on you helmet. it may not make a dome shape but it's easier and clean.
About the eyes, the bottom cut for me is a bit too low, try making it flater.