Hello 405th.
It's my first time posting pictures on the forum, and I'm needing some advice at the same time.
I'm building IM's armor using the files from Robo. The helmet is Sharkmark's, but I think I'll do that as the final piece of armor. I guess building the helmet gives some sense of the armor being complete, and the process of building armor slows a lot..
Here goes:
Back:
Glove (right):
The first problem I encountered was in the glove I made. No problem with the fingers, they may fall sometimes, but I want to glue them to a rubber glove, so no issues there. The problem is in the palm.
As you can see, I left an opening there, so that I could put my hand through. Of course I can close it after putting my hand there, but I would have to open it again to take my hand out. I have already built a smaller glove, that was too small for me, scaled it up 10% and had this results. Now, I think this might not be the correct thing to do, but I just glued all the pieces together, and maybe I just have to keep them all separated so I can glue them to a rubber glove so that all the pieces can move freely.
Any suggestions?
Thanks
It's my first time posting pictures on the forum, and I'm needing some advice at the same time.
I'm building IM's armor using the files from Robo. The helmet is Sharkmark's, but I think I'll do that as the final piece of armor. I guess building the helmet gives some sense of the armor being complete, and the process of building armor slows a lot..
Here goes:
Back:
Glove (right):
The first problem I encountered was in the glove I made. No problem with the fingers, they may fall sometimes, but I want to glue them to a rubber glove, so no issues there. The problem is in the palm.
As you can see, I left an opening there, so that I could put my hand through. Of course I can close it after putting my hand there, but I would have to open it again to take my hand out. I have already built a smaller glove, that was too small for me, scaled it up 10% and had this results. Now, I think this might not be the correct thing to do, but I just glued all the pieces together, and maybe I just have to keep them all separated so I can glue them to a rubber glove so that all the pieces can move freely.
Any suggestions?
Thanks