adirtygaspump
New Member
armercrazy said:Ok, so the resizing bit was the biggest pain in the neck for me to figure out. This is what's up: In the pepakura viewer, you cannot re-size your armor; there just isn't a feature for that. You will need pepakura designer 3 (or 2 or whatever. I use 3) which you can find online if you look hard enough. in this program, there is a feature for editing the scale of your armor. open this handy little doohicky, (it's in the 2-D menu...) and a little window will pop up and have 3 options for you: height, width and depth or whatever. Been a while since I re-sized anything. But basically, you change one of these numbers, and the others will all change with it. So enter your height in inches, or cm, whichever it asks for, and the other numbers will change for you. You may need to re-adjust the fittings on your 2-D side, the part on the right with the paper layout and all, but your armor should be re-sized for you now. Hope this helps, it's a little cryptic, but I don't have my regular pepping computer with me right now. I'll get ya some better info when I can. Clear as mud?
I have figured out how to use the scaler (thank you!) , I just converted my height from inches to mm.
Well, I have designer 3, and now I have 110lb cardstock paper, and it won't print. Do I need another version of Pep to print it out? I can't figure out if it's my printer or what. But when the printing que comes up, my printer thinks it needs to print over 100 pages to make the Mark VI helmet :S
-117
Last edited by a moderator: