Looking For An Old 3D Print File


SquishyShoes

Well-Known Member
I checked my harddrives at lunch and have had a bit of a geez about the web to little success. Only found two models one that would suck to try and 3d print, and the other is the obj in the armory here that you'd have to split up to print.
Have you tried sending a pm to Mendez? It says he was last online in May and he may have his private messages set to email him when gets one?

Good luck.
 
This thread is more than 9 months old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top