Mark V B EVA /3d print hybrid thing (Idk im not a expert)

Yes, it's worth the spurge imo

It costs $40, If you make two pieces the wrong size, it will cost you the same. It's nice that it's a lifetime license so you'll never have to pay for it again
 
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top