Pepakura Mojlnir Gen 3 Combination Torso project

rickrtickr

Well-Known Member
Member DIN
S259
Well, folks, the time has finally come!

After clearing a lot of free project time, I am happy to show off my next project!

I am going to create a 3-part torso combination of the Halo Infinite MK VI Gen 3 torso.
It will consist of the standard MK VI torso front and back, but also include a tightly modified MK IV front. (see pictures)

download.jpg
mk iv.jpg


To start with, I am going to construct the MK VI torso from my Pepakura Unfold:

organized unfold 5.PNG


After scaling, I have 42 pages to cut out, fold, glue, and harden.

20250613_073107.jpg
20250613_073111.jpg


After that, I will also be using the standard MK IV pepakura unfold for the interchangeable front section:

halo-wars-mjolnir-mkiv-chest-a.JPG


This is by far the most ambitious single project I have undertaken to date for my armor. but once completed it will likely be my favorite piece.

I will also be cross-posting the Cliff Notes of this build to my general updates thread. But I figured that a dedicated Pepakura construction thread would be worthwhile for this part.

Look forward to updates here!
 
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top