1st Build My first odst build!

The Trickster

New Member
1000003137.jpg
 
Looks like your using the AndrewDFT files. That is a great place to start learning foam building. You definitely are off to a good start.

I would recommend checking out Fallen and RandomRanger's Foam Guide here on the Forum and reading up on their tips and tricks:
 
Really nice foamwork! I can speak from personal experience to say that buckles to connect the two lower sides on the chest beneath the arms are a must to get in and out of the armor easily. Also applying some reflective film over the visor makes the helmet look a ton better and is really cheap. Let me know if you have any questions, I’m sure me or someone else can answer them.
 
Thank you very much! I have started work on the leg plates and the stomach plate. I should be done in 3 days. I will keep you updated on my progress!
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top