New Armor Project Halo 3 Marine

Very little

Just good print orientation and drowning it in filler primer
I thought my orientation was good. Is there any issues you’ve noticed drowning them with filler vs sanding then filling then sanding more? I know when I was using filler I was told it COULD cause issues but I don’t actually know what they would be in case you were wondering
 
I thought my orientation was good. Is there any issues you’ve noticed drowning them with filler vs sanding then filling then sanding more? I know when I was using filler I was told it COULD cause issues but I don’t actually know what they would be in case you were wondering
Huh odd
I haven't had a problem yet
But thanks for the heads up
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top