Foam Rakshasa core wip

RadMax117

Member
Member DIN
S707
Almost ready to plasti dip and paint! Almost everything foam except 3D printed knife, sintra pvc board for hand plates, buckles, machete (which will go on back, not chest attachment)
628F3E17-79DB-460E-AA21-42252ADDBB4E.png
96CAAD5F-6752-4DAC-8FD7-62D812FC13FE.png
88AE498D-F8BA-47DF-8639-FB975AC13C3E.png
DF0BF227-35C6-4F63-B5CD-355EA9C9E2F6.png
5E57D383-32E7-4D76-94DC-58DA00F32513.png
2AB0A130-B072-4578-9936-CAACA46C36A6.png
93F17B5B-86C4-4851-B644-7813127C271C.png
4B46F050-3CB9-4CE1-8614-55109290D1A1.png
9D5C9A91-A131-449B-93B7-6D9ADA9FEEB8.png
C033E464-D946-4D90-90C5-BC1C9D8F163C.png
 
Dude this is AMAZING! How long have you been working on it?? You did an especially good job on the foam helmet (they can be really tricky!) and that sangheili skull is fabulous. Can't wait to see it when it's done!
 
Holy crap! Fantastic job, especially with the elite skull! I'm absolutely ecstatic to see your suit and how it pans out!

(btw are those real bullets??? absolutely stunning)
 
Holy crap! Fantastic job, especially with the elite skull! I'm absolutely ecstatic to see your suit and how it pans out!

(btw are those real bullets??? absolutely stunning)
Thank you! And yea they’re real/inert .50 cals!
 
This thread is more than 12 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top