DavidGTodd
New Member
Hello everyone, My name is David. I'm 30 years old and have been a fan of the Halo series since the beginning. I have been a short time lurker of this site and I am always amazed at the builds you guys manage to achieve. I decided that I wanted to build a set of spartan armor about a month ago and started doing the research. This obviously led me to this forum. I have decided to do a pepakura build of the Mark VI armor from 4/5. I gathered my materials, purchased and downloaded pepakura designer 3, and set about figuring out my sizing for the print. The armor files that I downloaded were from master designer and are extremely detailed. The helmet has 200 pieces and is very tightly packed onto the 8.5 x 11 sheets of paper. The scale seemed close to what I needed so I went ahead and printed the helmet. Now that I have a few pieces together I think I'm going to have to figure out how to make it a little bigger. I'm 6'6 so I probably need to re-scale the helmet. Some of the pieces filled the 8.5x11 paper so I'm not sure what I'm going to do about that.
I'll post some pictures when I get back to my house. I just wanted to say hello and start logging this journey. My goal is to go to one of the Comic-Cons. I have never been and think it would be an absolute blast.
Thanks for reading and I can't wait to meet all of you!
I'll post some pictures when I get back to my house. I just wanted to say hello and start logging this journey. My goal is to go to one of the Comic-Cons. I have never been and think it would be an absolute blast.
Thanks for reading and I can't wait to meet all of you!