i actually have some of this foam laying around and might use it to do this, how are you getting such clean cuts in the foam, also would it be possible to get your blueprints, pm me if you can send them and i will give you my email.
Very early stages, but it looks like its setting up to be a great build. I like how you're using a NERF trigger + grip assembly. Also, the MDF core with foam sides is nice too, it should definitely give you a strong, but light end product. Keep it up!
Very early stages, but it looks like its setting up to be a great build. I like how you're using a NERF trigger + grip assembly. Also, the MDF core with foam sides is nice too, it should definitely give you a strong, but light end product. Keep it up!
i actually have some of this foam laying around and might use it to do this, how are you getting such clean cuts in the foam, also would it be possible to get your blueprints, pm me if you can send them and i will give you my email.
I use a modified hotwire cutter, instead of the wire being vertical I stretch it horizontally then I put the foam through it to make paper thin sheets.