noobbuilder
New Member
Hello all, I'm in the middle of trying to piece this helmet together. Unfortunately for me, I skimped out on speed over quality and now It's reasonably a bit roughed up, mainly on the inside at corners and tiny nooks and crannies, also where the 3D printed brim/skirt used to be. Towards the back of the top (so sorry for all the tape) there's a very apparent gap that came to exist after I carelessly processed it through Meshmixer; which I know I'll have to seal up or fill in, I've chosen to deal with it later.
Unfortunately I've come to a sort of standstill because I'm not exactly sure how to connect the individual pieces together?
I've seen some people suggest using super glue, but I feel like that's too weak, and I want to avoid using contact cement as it seems like overkill and is insanely toxic. Any advice?
TLDR; worried about structure and post-adhesion of the print.
Unfortunately I've come to a sort of standstill because I'm not exactly sure how to connect the individual pieces together?
I've seen some people suggest using super glue, but I feel like that's too weak, and I want to avoid using contact cement as it seems like overkill and is insanely toxic. Any advice?
TLDR; worried about structure and post-adhesion of the print.