So I'm done with a few pieces of pep armor and want to try my hand at hardening it. But, I'm a little confused as to where to go after all the folding and gluing. Normally I would just resin the pep armor, wait for it to cure, then fiberglass then inside, right? But then after that, would I rip off the pep armor paper and start bondo-ing? I ask this because I've seen really good armor pieces where it's smooth where it's supposed to be and all, but then I've also seen some alright looking armor where you can still see all the fold edges and all.
Also, I've been reading about muslin cloth as a safer alternative to fiberglass? But I haven't been able to find any tutorials really on muslin
So...what exactly is this glue/flour mixture? And would I still have to resin the pep armor first before I put on the muslin? And...could I use that hardened form to mold...?
thanks!
Also, I've been reading about muslin cloth as a safer alternative to fiberglass? But I haven't been able to find any tutorials really on muslin
So...what exactly is this glue/flour mixture? And would I still have to resin the pep armor first before I put on the muslin? And...could I use that hardened form to mold...?
thanks!