Beginning my Halo Reach MKV (b) build

Infernalaxe

Member
Foam helmets can look just as if not better than most 3D printed helmets. The important part of any foamsmithing is patience and practice! I think you could do a really good foam helmet and I can't wait to see what you'll make!
Thanks, I'm going to take a stab at the ODST first. Then go from there. Gonna take my time and be meticulous with it.
 

Infernalaxe

Member
Need to paint the helmet and weather it, paint the AR and build boots and glove pieces and resize some more of it..thanks to Negativecacti for the armor. Helmet and AR are 3d printed, purchased and out together. Next armor suit will either be a MK VI or ODST not sure which and that one I will build from the ground up,so to speak...
 

Attachments

  • IMG_20230217_165812605.jpg
    IMG_20230217_165812605.jpg
    2.2 MB · Views: 27

Infernalaxe

Member
It's chrome window tint laminated. Real easy to do and pretty inexpensive. Did the same to my Mando helm
 

Attachments

  • 16770218375388937470998075302866.jpg
    16770218375388937470998075302866.jpg
    1.9 MB · Views: 4

Infernalaxe

Member
Looks great. I just started a MK V(B) build this last week and I hope I can get the proportions on everything as good as you did.
Thanks, this suit was mostly a gift and I had to resize a little bit of it. Not much. Just got real lucky. Going to start a new build soon just not sure what
 

Bowye

New Member
Looking good! 3d printing can be a pain, so I respect the switch to foam. Where you get the undersuit if I may ask?
 
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Top