SkyBox
New Member
Hi, I am in the early stages of my Halo 5 Noble Gen 2 Armor build I am currently just cutting all the paper out for each of the armor parts and putting them into seperate boxes so I dont have to worry about them till later. (except for a few pieces which seem very complex to unfold. Mostly the Chest plate because alot of the pieces are off the main pep pages and It gives me a headache to look at. anyways, I just have a few questions about bondo & fiberglass which I am sure have been asked on the site before but I would really like to know.
Bondo
1. How many layers of bondo do I apply, I know its about 3 coats for the helm but is it the same for other parts?
2. Should I find a specific section to do the Bondo at a time, So if I am doing the ChestPlate do the top right, wait, do the top left wait etc, then apply a second layer etc?
3. For the small crevices what do I do with them? Do I not bondo them at first then use bondo later, Do I not fill them at all, or do I just ignore them and go over them?
Fiberglass
1. for enclosed props like grenades and weapons do I resin the Inside, or do I just not bother fiber glassing and just apply a layer of resin on the outside.
2. Do I fiber and resin the other armor pieces like the forearms?
Outside of all of this I have a pretty good understanding of what to do.
Bondo
1. How many layers of bondo do I apply, I know its about 3 coats for the helm but is it the same for other parts?
2. Should I find a specific section to do the Bondo at a time, So if I am doing the ChestPlate do the top right, wait, do the top left wait etc, then apply a second layer etc?
3. For the small crevices what do I do with them? Do I not bondo them at first then use bondo later, Do I not fill them at all, or do I just ignore them and go over them?
Fiberglass
1. for enclosed props like grenades and weapons do I resin the Inside, or do I just not bother fiber glassing and just apply a layer of resin on the outside.
2. Do I fiber and resin the other armor pieces like the forearms?
Outside of all of this I have a pretty good understanding of what to do.