Props Building/3D Printing A Halo Reach Rocket Launcher

Status
Not open for further replies.
First post here, over the past few days I have split up the launcher 3d model I modeled last month and im getting ready to print it tonight, gonna be a long build.
269848
269847
 
UUUUU SWEEEEEET.
Looks very similar to mine, you can watch it also in the forum here.
you can also download my models if you whant to compare.
which tube diameter did you use?

good luck with further Prints :)
ComanderXXY
 
UUUUU SWEEEEEET.
Looks very similar to mine, you can watch it also in the forum here.
you can also download my models if you whant to compare.
which tube diameter did you use?

good luck with further Prints :)
ComanderXXY
woah yours looks mega good, my prints are quite bad in comparison, models look similar, but yours has way more functionality than mine, i used 2 inch pvc and modeled around that, probably not 100% accurate, but good enough for me !
 
UUUUU SWEEEEEET.
Looks very similar to mine, you can watch it also in the forum here.
you can also download my models if you whant to compare.
which tube diameter did you use?

good luck with further Prints :)
ComanderXXY
Going to download and give your model and go!
 
Status
Not open for further replies.
Back
Top