First Build - My Own Reach Character

Kusidai

New Member
Hey everyone,
I’m new to making armor and could really use some guidance on how to tackle my first build. I’m planning to create my own Spartan. I’ve done a good amount of research on both 3D printing and foam builds, and I understand the basic steps for each method — but I’m still torn on which direction to take.


Here’s what I have access to:


  • 2 Ender 3 printers
  • A decent amount of EVA foam
  • Armorsmith Designer (already purchased and getting familiar with it)

I’ve seen some amazing 3D printed suits and some incredible foam builds on here, and I’d love to hear from people who’ve done either (or both). I’m open to mixing the two as well if that’s recommended for certain pieces.


A few things I’d like advice on:


  • Is it realistic to print an entire suit on 2 Ender 3s, or would that be too much hassle/time/maintenance?
  • Would starting with a foam build be better for a first timer since it’s a little more forgiving?
  • Are there certain parts of a suit people recommend printing vs. building out of foam?
  • Any other general tips you wish you knew when starting your first armor build.

I’m excited to finally get started on this after all the research. Any help, advice, or recommendations would mean a lot!


Thanks so much, Spartans!
 
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top