Halo Reach first build

scglynn

New Member
Hey Everyone, this is my first Halo build using a 3d printer. The armor set that I will going to be on is my Halo Reach Armor!

Screenshot 2024-01-22 121906.png
 
This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top