Props Halo Reach Shotgun: Oddworks

Scrap Yard

New Member
This Halo Shotgun will be my second prop gun build and will be a lot of fun!


I could fit the gun on 4 Bambu 3D printer plates.
 

Attachments

  • Screenshot 2025-03-29 at 11.57.00 PM.png
    Screenshot 2025-03-29 at 11.57.00 PM.png
    493.6 KB · Views: 92
Last edited:
I would say comparing the Nerf Bulldog and the existing foam guns sold at shows would be good to see how details appear after manufacturing to see what adjustments need to be made for clarity.
 
I just started thinking about printing this today after carrying the DMR around all day. I can’t fit my hand into the grip properly whilst wearing gloves. Excited to see this come to life.
 
Update: Weather has been not nice at all! LOL I have been able to sand the gun, but no Filler Primer yet!
 
Last edited:
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top