Masternewbie
New Member
Hi,
I have downloaded a template for foam that L3x was kind enough to put out there. Being new at this...do I just print the templates out?
When I print them with 6-8 shapes on a page it seems too small to be people sized.
Also...are there tabs on these I disregard?
I "used to" think I was decent at thinking spacially in 3D....but I am...clueless how to begin.
Thanks...
I have downloaded a template for foam that L3x was kind enough to put out there. Being new at this...do I just print the templates out?
When I print them with 6-8 shapes on a page it seems too small to be people sized.
Also...are there tabs on these I disregard?
I "used to" think I was decent at thinking spacially in 3D....but I am...clueless how to begin.
Thanks...