Is there anyway to adjust the way it prints?

Not open for further replies.

Tiel terall

Jr Member
So that it uses more of the bottom half of my sheet of paper? Right now its using about 1/4 just for the 1/1 (row 1 col1)

Heres a pic. What I want to do would be to print it the other way around[attachment=726:g.jpg]
Set the edges to 5, thats as low as it will go if you keep clicking, and make sure your telling pepakura to use the right size of paper.
the only piece on the armor thats going to be partially cut of is going to be the thigh
but other than that nothing should be.
your layout is portrait thats why
change it to landscape in printer settings when you open up pepakura
Not open for further replies.