Looking for advice

Hopeful Recruit

New Member
Hello, I recently got underway making my first ODST cosplay and I'm making good progress using this resource:
Halo 3: ODST - UNSC ODST
However, I noticed It seems to be missing a few parts for the foam version (that's the material Im using). For example, I see the main chest piece armor section in the paper part, but I don't really have any experience turning paper Pepakura files into foam. Is there another resource that has foam versions? Or should I try to adjust the paper version to work for foam? Thanks!
 

Attachments

  • ODSTs.jpg
    ODSTs.jpg
    81.2 KB · Views: 59
I believe because the chest plate is so relatively simple in nature, being several large flat surfaces, most people just use the paper file for their Foam, since it does not need the extra modifications that other pieces might, which is why no one made a dedicated "Foam" version of the chest plate.
 
This thread is more than 9 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top