Mesh
Active Member
Okay so Hey! 
I decided that, because I didn't like the looks I got carrying around my DMR in public (Especially in a country where we don't have guns), I wanted my second favourite gun
And here is my process
I used this photo from google for the template, using the PosteRazor software, I printed it out in a size I liked
Here it is in life The nerf gun is the Nerf N-Strike RAIDER for size comparison. I transferred this onto some thick foam, and cut it out, and then I cut out the purple sections and transferred them onto normal, 10mm EVA foam.
Here is the foam base along with the added EVA foam, with the Carbine cut out The markings on the foam was from a previous attempt, before I used the Poster software to print out an actual template so ignore those..
And here's a better look
This was when I plastidipped it, you can see I have added a curved edge to the hand holes, I've added an old Lego wheel for the ammo counter, and wire coverings to detail the barrel
I didn't have a picture, but before I did the purple, I had sprayed one side with grey. I didn't do the other because it was the same colour as the plastidip so I saw no point but in hindsight it was a really bad idea, when I pulled the masking tape off, the uncovered plastidip came straight off too........
But finally, here's the Carbine next to my DMR! This is the good side btw
All I need to do is sort out the other side, and then it's done I guess, until then it's hide the one side from the camera
Next build, is a sliced DMR to replace the old one seeing my friend has now claimed it
I decided that, because I didn't like the looks I got carrying around my DMR in public (Especially in a country where we don't have guns), I wanted my second favourite gun
And here is my process
I used this photo from google for the template, using the PosteRazor software, I printed it out in a size I liked
Here it is in life
The nerf gun is the Nerf N-Strike RAIDER for size comparison. I transferred this onto some thick foam, and cut it out, and then I cut out the purple sections and transferred them onto normal, 10mm EVA foam.Here is the foam base along with the added EVA foam, with the Carbine cut out
The markings on the foam was from a previous attempt, before I used the Poster software to print out an actual template so ignore those..And here's a better look
This was when I plastidipped it, you can see I have added a curved edge to the hand holes, I've added an old Lego wheel for the ammo counter, and wire coverings to detail the barrel
I didn't have a picture, but before I did the purple, I had sprayed one side with grey. I didn't do the other because it was the same colour as the plastidip so I saw no point but in hindsight it was a really bad idea, when I pulled the masking tape off, the uncovered plastidip came straight off too........
But finally, here's the Carbine next to my DMR! This is the good side btw
All I need to do is sort out the other side, and then it's done I guess, until then it's hide the one side from the camera
Next build, is a sliced DMR to replace the old one seeing my friend has now claimed it
