I’ve seen some people make them out of thin foam coated in leather or flex seal. Not breathable, not super flexible. But another cheap option.anyone got any ideas on any other no break the bank materials
I’ve seen some people make them out of thin foam coated in leather or flex seal. Not breathable, not super flexible. But another cheap option.anyone got any ideas on any other no break the bank materials
well i had to order new filiment for the printer the junk i have now it start off printing really good then about midway or in other spots the filiment wil just break this stuff is true junk im at work now but i will edit this post with the name of the brand. i returned two boxes and had them replace them and these do the same thing so im going to go back to overture i had no issues with all 4 boxes... anyone else have any issues with other brands?
thanks i will have to order a roll and give them a try do you know what temp you run PETG i tryed running some this morning and it was like boogering up an i tryed my bed at 60 then 70 then 100 still same out comeI've had a lot of good luck with hatchbox at first but currently, I use e-sun. E-sun gives me consistent results.
thanks i will have to order a roll and give them a try do you know what temp you run PETG i tryed running some this morning and it was like boogering up an i tryed my bed at 60 then 70 then 100 still same out come
thank you i will try thatiformationFor petG, tool is at 245, Bed is at 110 (only because I don't want to re-level the bed when I swap from ABS for a quick print. Otherwise I think 60 on glass with glue is just fine). Here are the rest of the important information:
View attachment 291589 View attachment 291592
Gives me pretty decent results but I can also get away with my abs settings as well which prints at 235C and lower retraction.
MoeSizzlac - Do you have your printer in an enclosure?
That looks great! Since it’s one cast how do you put it on?
How did you die the neck seal?? Looks great