My Chief Helmet

Status
Not open for further replies.

04hower

New Member
Ok so ive been working on my helmet for some time.
Its made with fiberglass / resin etc etc
And i need a bit of help :/

Here are pic of my helm:

FRONT
[attachment=2064:DSC_0142.JPG]

BACK
[attachment=2065:DSC_0144.JPG]

LEFT
[attachment=2066:DSC_0143.JPG]

RIGHT
[attachment=2067:DSC_0145.JPG]

The inside is fiberglassed and resind (TWICE)
[attachment=2068:DSC_0152.JPG]

Well i have some problems:

1. I fiberglassed and resind the visor in :( but.... I am going to dremel it out.
2. A dip formed in the top of my visor when i fiberglassed. I filled the dip with resin but this led to big linesof resin running down the side of my helm.
[attachment=2070:DRIPS.JPG]
Is there a way i can get rid of these?
By the way i am only 14 so i dont have power tools (Sander etc)

ALSO!!!

A little info on my To-Be visor:

I am going to vacum form my visor by using the shape from my helm i will dremel out and then i get stuck...

Can anyone give me more info on the gold transparancy spray / tape etc ?

ooo

one last bit i am using normal chair foam to pad my helmet and hopefully getting some electronics in there too.
I have a tiny fan from an old networking hub which i am going to put in the bottom of the chin (so as to have fresh air to brethe). I also have an old mp3 player and small speakers i will install in the sides.

Many thanks

04HOWER

P.S i am sorry its such a long topic :(
 
Sorry, but it looks pretty deformed.
Im assuming you did this by pepakura right? What kind of paper did you use?
 
well, since u have a dremil I'm sure u have the sander attachment, just be very careful. :)

and the visor, go to a motorcycle supply website and but a motorcycle helmet visor use your dremil to cut.
 
Status
Not open for further replies.
Back
Top