My first Project in 2020... Making a Sangheili Elite

Status
Not open for further replies.

Kristoffer

New Member
Hi everyone,
Kristoffer here from Singapore.
Started building my very first Halo Costume in 2020.
Trying to make a Sangheili Elite from Pepakura files.
I just started to make the head 3 day ago.... to see if it work out fine for me.
So far I just build up this much...
IMG_20200803_030653.jpg

Hope is not too bad....
Will update once there is progress.
Thanks
 
that is awesome kris keep up the good work i will be watching this build i want to see how this comes out.
 
Awesome build do far. Do you plan on wearing it as a cosplay?
Thank you for the encouragement to keep me going building this project.... I was trying to make it wearable... See how I can modify it to see through from inside..... Need to build up the armor first and than do a test fitting for it... Look out for the update on this project
 
I was just asking because with all the pieces it would take to make a split jaw, it would get quite heavy going the cardstock paper way. Have you considered trying EVA foam?
 
I was just asking because with all the pieces it would take to make a split jaw, it would get quite heavy going the cardstock paper way. Have you considered trying EVA foam?
I never try EVA foam before.... i don't feel is heavy. if that the case i will try make a frame to support it if the is possible. come worst to worst just make it as a bust,..hehehe
 
Status
Not open for further replies.
Back
Top