ODST/Recon Build Progress


Foxcario

Member
IMG_20210509_164246_391.jpg
IMG_20210509_164246_397.jpg
IMG_20210509_164246_421.jpg


A little progress.
 

Foxcario

Member
The bottom part of this Recon helmet is a bit harder than I thought. But at least I'm using Pepakura viewer for references.
It's kinda hard to tell, but I just hot glued it on at an angle. No beveling (no angled cuts), and no shallow incisions. Just angled gluing. It's also a thin piece, so I can bend it the way I need it to.

20210524_222650.jpg


20210524_222705.jpg


20210524_222809.jpg


20210524_222839.jpg
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top