Rakshasa Grenadier

600 grit wet sand on the bondo spot putty.
1000018544.jpg
1000018545.jpg


Added the magnets to the helmets back plate. I add the neodymium magnets using JB Weld steel stick on one part, then I cover the magnets with clear wrap, after I add magnets and steel stick to the other side.
1000018549.jpg
1000018551.jpg

1000018552.jpg



White paint primer.
1000018559.jpg
1000018600.jpg


Red enamel paint added to the general areas I want red on the helmet and semi gloss black added to the UA attachment.
1000018614.jpg
1000018615.jpg

1000018616.jpg
1000018659.jpg
 

Attachments

  • 1000018616.jpg
    1000018616.jpg
    3.4 MB · Views: 10
Painted the back plate gunmetal.
1000018713.jpg


Tapped off the sections I want to keep.
1000018716.jpg


Semigloss black paint.
1000018717.jpg


Tape peel.
1000018740.jpg


For the main helmet, I tapped off the red I want to keep.
1000018714.jpg


Did a white base for the gun metal.
1000018715.jpg


Gunmetal.
1000018738.jpg


Tapped off gunmetal parts I want to keep.
1000018746.jpg


Semigloss black.
1000018749.jpg


Peel off all the tape.
1000018754.jpg
1000018756.jpg


The inner ear piece was difficult to cover in tape, so I hand painted a white base with acrylic paint.
1000018758.jpg


Then I sprayed the red paint into a disposable cup and used a brush to paint it by hand.
1000018759.jpg


Rub'n Buff bassed off of references from the game and areas I felt were right to hit.
1000018760.jpg
1000018761.jpg
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top