Shoulder plates


SpartanSweed

New Member
My shoulder plates came out a bit rougher than I would’ve liked so I might add some detail foam over it
 

Attachments

  • 98D9CB89-477D-48CC-8988-C96F6204199A.jpeg
    98D9CB89-477D-48CC-8988-C96F6204199A.jpeg
    675.5 KB · Views: 26

StattingUp

Member
Keep it up! Make sure you have a very sharp blade at all times. Foam is brutal on sharpness of blades.
Are you using Loctite, hot glue, or contact cement?
I started the same way with the shoulder/bicep, I ended up remaking them again because as I continued on I started to figure out more and more. You're doing the Mark IV halo 4 armor right?
 

SpartanSweed

New Member
Keep it up! Make sure you have a very sharp blade at all times. Foam is brutal on sharpness of blades.
Are you using Loctite, hot glue, or contact cement?
I started the same way with the shoulder/bicep, I ended up remaking them again because as I continued on I started to figure out more and more. You're doing the Mark IV halo 4 armor right?
I'm using loctite to keep it together, recently started reenforcing seams with some hot glue, and yeah this will (hopefully) become the Halo 4 Mark 6.
 

StattingUp

Member
I'm using loctite to keep it together, recently started reenforcing seams with some hot glue, and yeah this will (hopefully) become the Halo 4 Mark 6.
If you have any questions im actually doing the same exact build right now as well. I have the Chest and Helmet left to make so ive gone through most of the trials haha! The forearms and calves got pretty tricky for me
 

SpartanSweed

New Member
If you have any questions im actually doing the same exact build right now as well. I have the Chest and Helmet left to make so ive gone through most of the trials haha! The forearms and calves got pretty tricky for me
I'm just starting on the shins myself, not looking forward to the chest
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top