Undersuit?

[jokerdude04]

I am new here and I am wondering what everyone is using as an undersuit. I did some poking around the forum and I cannot find where people state where they got theirs.

 

[BRVSTR]

I use long sleeve compression shirt/pants as a base layer.

My ab wrap and shoulders are printed out of TPU which the designer (Titlewave Designs) offers as printable models. TPU's not really ideal around joints, though (it's too rigid when printed), so I'm switching to silicone molds offered by InstinctCreative3D for better mobility.

Others have made the soft parts of their undersuit out of EVA foam, too.

 

[billeybob250]

Mine is just compression pants, shirt, a shape wear stomach area, knee and elbow pads, and the back plate off a motor cycle jacket. i plan on making a foam ab wrap later.

 

[SpartanSweed]

Mines much of the same, compression gear, padded shorts. I know several members have made their abwraps out of foam wrapped in fabric/leather/pleather.

 

[jokerdude04]

I appreciate all this. I will be sourcing compression gear soon.

 

[Barbcelona]

Don't really have a good up-close pic. But here is my silicone undersuit from the mentioned InstinctCreative3D. It can be a little tricky, and mine didn't turn out perfectly. Also, here is an ab-wrap I made and used before I went the silicone route.