blowing bomb
Jr Member
so if i want to unlfold a file .obj or 3ds. etc
how would i go about doing that?
how would i go about doing that?
unfolding
- Thread starter blowing bomb
- Start date
- Status
Basically, you have to open it in Pepakura, and hit unfold, but I'm sure you know that. I'm not very good either, but just trying to make sure it'll be possible to cut, score, and put together. Maybe I'm wrong, but sizing might just have to be trial and error--once it's possible to cut, fold, and glue, I'd try printing it out and building it, then scaling it from there. I'll be quite honest with you though, I'm bad at unfolding, so maybe this won't help at all, but I hope it does! If you have more patience than I do, it should
!
!- Status
