Various props from Pokémon and Star Wars

TastyGumbo

New Member
So I started 3D printing recently and it’s been a bit tough but I am getting there and would like to share a few of the items I made while learning. They all have mistakes but each one you can see has an improvement. The bulbasaur was the first one and you can see I clearly forgot about supports, the second one is the venator star destroyer and you may not see it but the supports were way to thick and the third is the poke all which came out the best but has some minor issues
 

Attachments

  • IMG_1161.jpeg
    IMG_1161.jpeg
    1.8 MB · Views: 64
  • IMG_1162.jpeg
    IMG_1162.jpeg
    1.8 MB · Views: 61
  • IMG_1178.jpeg
    IMG_1178.jpeg
    1.7 MB · Views: 64
  • IMG_1179.jpeg
    IMG_1179.jpeg
    1.7 MB · Views: 60
  • IMG_1209.jpeg
    IMG_1209.jpeg
    1.7 MB · Views: 66
This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top