3D Printed MK VI Master Chief

MrJamin

Member
Are you going to build it out more like a mannequin or leave it a stick figure underneath?
 

MrJamin

Member
Do you have any pictures / details on your undersuit / how you attached the armor?

I know I am getting ahead of myself since I have less than 1/2 of it printed, but I like to plan these things out
 

JGPenland

Member
Do you have any pictures / details on your undersuit / how you attached the armor?

I know I am getting ahead of myself since I have less than 1/2 of it printed, but I like to plan these things out
I’ll take pics of each armor part tonight, shins, shoulders, and forearms are all just padded inside and just slide on my arms and legs, the thighs are attached by straps to a belt to hold them up, cod is attached to the rear with elastic and buckles.
 

Jalle

New Member
I’ll take pics of each armor part tonight, shins, shoulders, and forearms are all just padded inside and just slide on my arms and legs, the thighs are attached by straps to a belt to hold them up, cod is attached to the rear with elastic and buckles.
i would love to see the pictures, it would help me sooo much. ive started printing a MK VI
 

Sharpworks

Jr Member
I know this thread is kinda 'old' but I have to say it... That suit is the one of the coolest one's I've seen so far, and I love the undersuit! I was originally planning to just wear a black shirt and pants but I think I might have to make myself an outfit from that material. How comfortable is it? And is it breathable?
 
Top