ArktosPendragon
Active Member
1)Okay, I just finished building a Mk VI helmet and it turned out a little small. Now, I (in my noobish ways) thought I could just print it out the way it was. So after I had the knowledge that I needed to scale it, I poked around a little. I found a thread on how to do that and the method seemed pretty good. I found out you cannot scale it in viewer so I downloaded designer. I brought it up and went to scale it. In every thread I read the method starts off with the default size which is like 30.-------- but, every file I use is Between 2 and 0.
Now, what am I doing wrong?
2)I have only printed a few pep pieces so far and I haven't had to many problems. But, whenever I try to print files that are like this
It prints it vertically even if I set it to landscape mode.
3)For some unknown reason (to me at least) I cannot rotate models in Pep designer. Anyone know why?
Thanks in advance everyone.
Now, what am I doing wrong?
2)I have only printed a few pep pieces so far and I haven't had to many problems. But, whenever I try to print files that are like this
It prints it vertically even if I set it to landscape mode.
3)For some unknown reason (to me at least) I cannot rotate models in Pep designer. Anyone know why?
Thanks in advance everyone.