so heres my plan to world domination with the energy sword.
first off, using transparent sheets of paper for the blades. yes, it works and i have tested it! it does not smudge if you print it the right side and leave it to dry for about 15 seconds.
secondly, the handle is finished but the tapejob sucks...literally.
thirdly, glassing just the handle, i think the transparent will hold up nicely.
fourth, led lights and switch in the handle. just blue would be perfect, dont you think?
fifth, after glassing and led wiring is complete, assemble the two parts.
conclusion: this may take between a week and 3 months to finish, as i need money! ASAP
if i can get the button-switch inside my handle, and a bigger hole for my ground source, i think this my become the next epic sword!
first off, using transparent sheets of paper for the blades. yes, it works and i have tested it! it does not smudge if you print it the right side and leave it to dry for about 15 seconds.
secondly, the handle is finished but the tapejob sucks...literally.
thirdly, glassing just the handle, i think the transparent will hold up nicely.
fourth, led lights and switch in the handle. just blue would be perfect, dont you think?
fifth, after glassing and led wiring is complete, assemble the two parts.
conclusion: this may take between a week and 3 months to finish, as i need money! ASAP
if i can get the button-switch inside my handle, and a bigger hole for my ground source, i think this my become the next epic sword!