Eva foam ODST build

Thread starter KnightMare
Start date Yesterday at 6:31 PM
Tags

eva foam odst eva foam odst helmet

KnightMare

New Member

Yesterday at 6:31 PM

So after a year of watching videos and messing up foam, I finally decided it's better to make a suit and get it out of the way than to wait any longer. I built the helmet today by Andrew DFT's template and ran into a multitude of problems that were mainly fixed with an extensive amount of hot glue and a mild dash of cursing. My two remaining issues are 1: I have open/ugly seems between some of the pieces, and 2: it doesn't go past my chin. I think I have an idea to bead hot glue down the seems to simulate weld lines, but does anyone else have the same problem as me for the chin? Thanks

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.